Email Us
News

Adding an Equipment Branch? Check All Three Ports of the Threaded Tee

2026-11-12 0 Leave me a message

A skid builder is adding a branch to a stainless steel utility line. The two connections on the main run are already specified, and the equipment adapter has a male pipe thread. The drawing calls for a threaded tee, but the parts list gives only a nominal size. Before the order goes out, the buyer needs to confirm whether the adapter will screw directly into the branch and whether both run ends match the adjoining fittings.

Identify the run ends and the branch

An M/M/M tee has three male-threaded ports. Each mating connection must have a compatible female thread. An M/F/M tee has two male-threaded ports and one female-threaded port. Check the supplier’s drawing to confirm which port is female.

In this example, the equipment adapter can connect directly if the female port is on the branch and the thread and sealing arrangement match. If the female port is on one of the run ends, the same tee will fit a different layout. A sketch labelled Run A, Run B and Branch gives the supplier a clear way to confirm the configuration.

Check how each joint seals

Record the exact thread designation for each port. NPT is covered by ASME B1.20.1. ISO 7-1 covers pipe threads for joints that seal on the threads. With ISO 228-1 parallel threads, a pressure-tight assembly requires a seal outside the threads. Check the mating component’s drawing for the sealing arrangement as well as the nominal size. ASME B1.20.1 · ISO 7-1 · ISO 228-1

Turn the branch detail into an RFQ

Start with Include in the RFQ What it helps confirm
Piping sketch Label Run A, Run B and Branch. Mark each port as male or female. The orientation of the tee and the location of the female port.
Mating component drawings Give the size, thread designation and sealing arrangement for each connection. Whether each component can connect directly.
Line specification Give the required stainless steel grade, service medium, design pressure and temperature, and quantity. Whether the quoted fitting suits the intended service.

Before releasing the purchase order, compare the quoted port layout with the piping sketch and check that there is room to install and tighten the equipment adapter. For a quotation, send Lianhe the sketch and line specification with your request. Lianhe Class 150 threaded fittings · Contact Lianhe

Related News
Leave me a message
Mobile
+86-18621531073
Address
Building 2, No.3991, Binhai 3 Road, Wenzhou Economic Technological Development
X
We use cookies to offer you a better browsing experience, analyze site traffic and personalize content. By using this site, you agree to our use of cookies. Privacy Policy
RejectAccept